Filter
Top Products
14 - 9
14 ROM OPERATION FUNCTION
(3) ROM operation procedure
The flowchart to start the ROM operation is shown below.
Mode operated
by RAM
ROM operation start procedure
Installation mode
mode written in
ROM (Install the
operating system
software.)
Set "Installation mode mode written in
ROM" as a DIP switch 5 of the Motion CPU
module.
Create or correct the system setting,
parameters and programs using SW6RN-
GSV P, and write to the Motion CPU
module.
(Note)
Install the operating system software to the
Motion CPU module using the SW6RN-
GSV P.
Set "normal mode" as a DIP switch 5,
and set "Mode operated by RAM" as a DIP
switch 2 and 3.
Turn ON again or reset the power supply
of Multiple CPU system.
Execute the trial run and adjustment.
Set "Installation mode mode written in
ROM" as a DIP switch 5.
Check the operation
Execute the "ROM writing" of the program
and parameter using the SW6RN-GSV P.
ROM operation start
Turn ON the power supply of Multiple CPU
system.
YES
NO
(Note) : Do not execute the ROM writing for program and parameter while installing
the operating system software.
Set "normal mode" as a DIP switch 5, and
set "Mode operated by ROM" as a DIP
switch 2 and 3.
Turn ON again or reset the power supply
of Multiple CPU system.
Installation mode
mode written in
ROM
(ROM writing.)
Mode operated
by ROM
Turn ON again or reset the power supply
of Multiple CPU system.