Filter
Top Products
13 - 4
13 LIMIT SWITCH OUTPUT FUNCTION
13.2 Limit Output Setting Data
Limit output data list are shown below.
Up to 32 points of output devices can be set.
(The following items of No.1 to No.5 are set together as one point.)
No. Item Setting range
Fetch
cycle
Refresh
cycle
Remarks
1 Output device Bit device (X, Y, M, L, B) —
Operation
cycle
2 Watch data
Motion control data/
word device (D, W, #, absolute address)
(16-bit integer type/32-bit integer type/
64-bit floating-point type)
ON Value Word device (D, W, #)/constant (K, H)
3
ON region
setting
OFF Value Word device (D, W, #)/constant (K, H)
4
Output enable/disable
bit
Bit device (X, Y, M, L, B, F, special relay)/
none (default)
ON : Enable
OFF : Disable
None : Always
enable
5 Forced output bit
Bit device (X, Y, M, L, B, F, special relay)/
none (default)
Operation
cycle
—
None : No forced
outputs are
always made
(OFF status)
(1) Output device
(a) Set the bit device which outputs the ON/OFF signal toward the preset watch
data.
(b) As the output device, the following devices can be used.
Item Device No. setting range
Input relay
(Note-1)
X0 to X1FFF
Output relay
(Note-2)
Y0 to Y1FFF
Internal relay
(Note-3)
M0 to M8191
Latch relay L0 to L8191
Link relay B0 to B1FFF
(Note-1) : PX is write-disabled and it cannot be used as the output device.
For X, only the free No. of the input card non-loading can be used.
(Note-2) : The real output device range (PY) is also included.
(Note-3) : M2001 to M2032 cannot be used to the output device.
Be careful because it affect a positioning operation, when the positioning
dedicated devices are set.