Filter
Top Products
1 - 96
1 OVERVIEW
1.6.3 Setting I/O No.
The procedure for the I/O No. setting for the Motion CPU in System Settings of
SW6RN-GSV
P is shown below. In the Motion CPU, by setting a module used in
each CPU base or extension base slot in System Settings, the control CPU of the
applicable slot is assigned as the self CPU. Input modules, output modules and
composite I/O modules require an I/O No. to be set.
Refer to the help of SW6RN-GSV
P for the detailed operating procedure on the
System Settings screen.
1) Double-click the slot position, display
the Motion Slot Settings dialog box.
2) Select the I/O module.
4) Select applicable module type
and number of points for
the I/O module to be used.
3) Click [Detail Setting].
5) Set the first I/O No.
(PX No., PY No.).
6) Click [OK].
<System Settings>
<Motion Slot Settings>
<I/O Module Settings>
(Note): Display of system setting and motion slot setting are different depending on the operating system
software.
POINT
I/O No.s cannot be assigned automatically, unlike a PLC CPU for which I/O No. are
assigned automatically if such setting is omitted in the Motion CPU. In the Motion
CPU, be sure to set the first I/O No. in System Settings for each module used.