Filter
Top Products
68 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
Adding New Stations to an ACS
The following is an example of JCL for the SET utility that can be used as a pattern for
adding new stations to an ACS without requiring a reconfiguration.
Note: Update LIBGEN control statements to make changes permanent. You do not have
to execute the Reconfig utility to implement these changes. Refer to “Reconfiguration
Utility” on page 225 for more information about reconfiguration.
JCL to Add New Stations to an ACS
Notes for the Example
1. The first SET control statement defines the listed stations for only one host.
Note: All stations must be specified (not just the new ones).
2. The second SET control statement defines the listed stations for all hosts.
Note: All stations must be specified (not just the new ones).
3. The following are installation dependent:
- SLSCNTL data set
- SLSCNTL2 data set
- station identifiers
- ACS numbers
-host IDs.
4. The standby CDS is not required for this JCL.
//HSCUPDAT JOB (acctno),’LMU STATIONS’,MSGCLASS=1,CLASS=A,
// MSGLEVEL=(1,1)
//STEP0 EXEC PGM=SLUADMIN
//* The following DD is the HSC STEP library
//STEPLIB DD DSN=SLS.PROD.LINKLIB,DISP=SHR
//SLSPRINT DD SYSOUT=*
//* The following DD statement identifies the HSC primary CDS
//SLSCNTL DD DISP=SHR,DSN=SLS.DBASE1
//* The following DD statement identifies the HSC primary CDS
//SLSCNTL2 DD DISP=SHR,DSN=SLS.DBASE2
//SLSIN DD *
SET SLISTATN(0CD,0CE,0D0,0D1) FORACS(0) FORHOST(HST1)
SET SLISTATN(0CD,0CE,0D0,0D1) FORACS(0)
//