Filter
Top Products
380 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
=NODEBUG
This diagnostic command terminates the special ‘‘debug’’ mode. ‘CP SET RUN ON’ is
also executed.
=
the command character for the DIAG subsystem. The default is ‘‘=’’, but may be set
to any character by the SUBSYS command that started the subsystem.
=DDICT
This diagnostic command displays data dictionary information describing an SCP or HSC
data area fieldname.
The information returned is the assembler definition of the field with the DSECT name
and the offset from the DSECT.
‘CP SET RUN OFF’ is executed, and the SCP debug mode is entered. The diagnostic
command ‘=NODEBUG’ terminates the debug mode.
=
the command character for the DIAG subsystem. The default is ‘‘=,’’ but may be set
to any character by the SUBSYS command that started the subsystem.
fieldname
the name of a field in an SCP or HSC data structure.
Examples:
Issuing the command:
=DDICT LVTSSCVT
Results in:
LVT: LVTSSCVT+000C DS A
Issuing the command:
=DD ATPARM
Results in:
ATNAME: ATPARM +0018 DS (16)A
Issuing the command:
=DD CMDTOKS
Results in:
CMDTOKS: CMDPLIST+00CC DS (32)XL(4)