Filter
Top Products
Chapter 3. HSC Control Statements and HSC Start Procedure 153
1st ed., 6/30/04 - 312579601
Notes:
1. If MAXclean is not specified in the VOLATTR statement, the value or default
of the MAXclean parameter in the MNTD operator command is used for all
cleaning cartridge counts.
2. If MAXclean is specified, the MEDia setting must be Standard, DD3D,
STK1U, or STK2W.
Example
The following example illustrates how to use VOLATTR statements to specify volume
attributes for particular VOLSERs.
Set Volume Attributes
Notes:
1. Ask your StorageTek CSE about recommended MAXCLEAN values for specific
types of cleaning cartridges.
2. In the example above, the last VOLATTR statement specifies a user-defined default
for all volumes that do not match any of the previous statements.
3. Note that recording technique is specified on all VOLATTR statements in the
preceding examples, since the last statement specifies a RECtech(18), which is not
the default (LONGI). If RECtech were omitted from the previous MED(S)
VOLATTR statements, the REC(18) from the last VOLATTR statement would be
used.
VOLATTR SERIAL(L*,AA9*) MEDIA(ECART)
VOLATTR SER(S*,PRD000!PRD499,BY*) MED(S) RECTECH(36)
VOLATTR SER(CLN200!CLN299) MED(DD3D) REC(HEL) MAXCLEAN(50)
VOLATTR SER(CLN300!CLN599) MED(S) REC(LONGI)
VOLATTR SER(*) REC(18)
VOLATTR