Filter
Top Products
166 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
Initializing the HSC to the Full Service Level
Normally, HSC software is initialized to the full service level when it is started. The
syntax for the commands used to initialize the HSC to the full service level is shown
below.
Syntax for Initializing HSC to Full Service Level
AUTOLOG svmname pswd - or - ACS INIT - or - ACS SUBMIT strtjclfn strtjclft
strtjclfm libclass.
AUTOLOG svmname pswd
- or -
ACS INIT
- or -
ACS SUBMIT strtjclfn strtjclft strtjclfm libclass