Filter
Top Products
Chapter 3. HSC Control Statements and HSC Start Procedure 165
1st ed., 6/30/04 - 312579601
Starting the HSC
The HSC software can be initialized in three ways:
• Start the ACS service machine via the CP AUTOLOG command.
• Issue the ACS INIT command from the service machine virtual console.
• Submit the HSC startup SLKJCL to the ACS service machine, if the SCP is already
executing but without the HSC.
Parameters associated with the /PARM statement in the HSC startup SLKJCL (see
“Creating an SLKJCL File for Starting the HSC” on page 157) can also be supplied via a
PARM= option with the ACS INIT command and the ACS SUBMIT command.
Specifying the PARM= option appends the parameters specified to the parameters on an
existing /PARM statement, or creates a new /PARM statement. In this way, most of the
startup parameters can be overridden.
The HSC can be initialized to a full or base service level via parameters on an existing
/PARM statement in the startup SLKJCL, or by issuing the ACS INIT or ACS SUBMIT
commands with the PARM= option.