Filter
Top Products
Chapter 4. Utility Functions 277
1st ed., 6/30/04 - 312579601
The RESTore utility does not reset the journals. It is recommended that a backup be
performed following the completion of the restore to reset the journals and reflect the
newly restored control data set.
Special Considerations for Control Data Sets Processing Independently
Special precautions should be taken for running BACKup and RESTore when
local/remote-linked libraries run control data sets independent of each other. These
precautions should be followed when the link connecting the local and remote libraries is
disrupted. Refer to “When CDS Copies Are Split Among Hosts After an Error” on page
213 for more information.
Syntax
Utility Name
RESTore
specifies that the restore operation is to be performed.
Parameters
APPly
optionally specifies whether or not the journals are to be applied to the restore
operation.
(YES)
specifies that journals are to be applied. YES is the default.
(NO)
specifies that journals are not to be applied.
GENerate
optionally specifies what statements are output to the SLSAUDIT data set and
whether or not control data sets are restored.
(NO)
specifies that NO statements are sent to the SLSAUDIT data set. The control
data sets are also restored. NO is the default.
(YES)
specifies that statements are sent to the SLSAUDIT data set. The control data
sets are also restored.
RESTore
APPly( NO
YES
) GENerate(
Only
Short
YES
NO
)
Restore