Filter
Top Products
Chapter 4. Utility Functions 331
1st ed., 6/30/04 - 312579601
MEDEQUAL
specifies that volumes for which the media types of the VOLATTR and the
VAR are equal match the criteria.
NONMEDEQ
specifies that volumes for which the media types of the VOLATTR and the
VAR are not equal match the criteria.
NOEXTernal
NOEXTernal specifies that volumes without an external label match the
criteria.
For example, INCLUDE(SEL,ERR) tentatively chooses only selected and
errant volumes for the report. INCLude parameters are applied before
EXCLude parameters in volume selection.
EXCLude
optionally specifies the criteria for excluding volume information from the report.
Any volumes that match one or more of the exclusion criteria are excluded from the
report.
EXCLude parameter values are the same as INCLude values, except for the
‘‘*’’ parameter (see the INCLude options list above).
As an example, EXCL(NONSEL) excludes nonselected volumes from the report.
Notes:
1. INCLude parameters are applied before EXCLude parameters in volume
selection.
2. Parameter values are not checked for the existence of their opposite values (for
example, ‘‘SEL’’ is still flagged even if ‘‘NONSEL’’ is specified, and vice
versa).
3. Positive attributes are applied before negative attributes (for example, SCR is
applied before NONSCR).
4. EXCLude is not available if Volume Report is running under SCP.
VOLDATA
optionally specifies that a flat file, not a volume report, is to be produced.
When this keyword is specified, the utility attempts to write the volume data to a data
set defined by the SLSCDATA DD statement.
If both VOLDATA and CDSDATA (see below) are specified, a single flat file is
produced that contains volume and non-volume information.
Note: VOLDATA is not available if Volume Report is running under SCP.
Volume Report