Filter
Top Products
Chapter 4. Utility Functions 175
1st ed., 6/30/04 - 312579601
CMS Environment
For utilities that run in the CMS environment, an edit session of an EXEC 2 file is
presented for you to modify. The file identifier is ACSCMS EXEC.
Note: For systems running VM ESA Version 2 or higher, utilities that are run in CMS can
run in XA or XC mode with SET 370ACCOM ON. For VM ESA below Version 2,
utilities run in CMS must run in 370 mode.
For example, entering:
EXEC ACS UTIL SLUACTV
produces the edit session display of this ACSCMS EXEC file:
ACSCMS EXEC
If you decide not to execute the utility, then enter the XEDIT command QUIT.
To execute the utility, perform the following steps:
1. Delete the lines in the template that are not required, or leave the comment indicator
(*) in column one.
2. Remove the comment indicator (*) from the desired lines.
3. Specify values for the desired parameters.
4. Delete the parameters that are not desired.
SET Change library configuration information
SLICREAT Library control data set creation
SLIMDisk Allocate an OS-format data set on a minidisk
SLIVInt Initialize a volume in OS format
SLSBINIT Create HSC startup job
SLUACtv Activity distribution report
SLUETRac Format trace records
SLUPErf Reblock performance log data
TRAce Format execution trace data
UNSCratch Change volumes to non-scratch status
UNSElect Unselect a volume that was left selected by HSC
VOLRpt Volume location report
&TRACE ALL
* EXEC SLUACTV <ctlfname|SLUACTV> <ctlftype|PARMS> <ctlfmode|*>