Filter
Top Products
228 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
Output Description
Outputs resulting from the execution of the Database Decompile utility include:
• a valid LIBGEN file matching the existing control data set. The output file has the
following characteristics:
- All station and drive addresses are 4-character addresses.
- In cases where multiple parameters point to the same label statement, the utility
duplicates the statement with a unique label and points each parameter to a
different, although identical statement.
- Labels generated in the output LIBGEN are listed in Table 12.
- If an EJect password exists, it is not displayed. Instead, the following line is
displayed: EJCTPAS=????????
• messages associated with error conditions resulting from an unsuccessful execution
of the utility.
Refer to Figure 12 on page 229 for an example of output from the utility.
Table 12. Label Descriptions for Devices in Output LIBGEN
Device Label Description
ACS ACSaa aa is the sequential hexadecimal ACSid value
(00 through FF), beginning with zero.
LSM LSMaall aa is the ACSid, and ll is the sequential
hexadecimal LSMid value (00 through 17),
beginning with zero.
STATION STaah aa is the ACSid, and h is the sequential
hexadecimal host index value (0 through F),
beginning with zero.
PANEL Paallpp aa is the ACSid, ll is the LSMid, and pp is the
sequential decimal panel number (0 through 10).
DRIVE Daallpph aa is the ACSid, ll is the LSMid, pp is the
decimal panel number, and h is the hexadecimal
host index value, beginning with zero.
Database Decompile