Filter
Top Products
382 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
Results in CP QUERY PER output. The following output is for VM/SP, VM/SP
HPO, and VM/ESA 370.
1 INSTRUCT RANGE addr TERMINAL NORUN CMD * FUNC=SLSBINIT OFFSET=000000
2 INSTRUCT RANGE addr!addr TERMINAL NORUN CMD * FUNC=SLKODE OFFSET=000054
The following output is for VM/XA and VM/ESA.
=WHERE
This diagnostic command displays the module location of a named program module (and
the date/time of last assembly), or the module name which contains a given address.
‘CP SET RUN OFF’ is executed, and the SCP debug environment is entered. The
diagnostic command ‘=NODEBUG’ terminates the debug environment.
=
the command character for the DIAG subsystem. The default is ‘‘=,’’ but may be set
to any character by the SUBSYS command that started the subsystem.
epname
the name of a known entry point. It is either named in the map within any
‘SLKNUCxx’ module or there is a CDE structure for the name.
If the name is known, it will be located in storage. It will be LOADed into storage if
it was not there before.
address
any storage address. If it is within a known module, the module and entry point
names and the offsets from each will be returned.
NAME INITIAL (ACTIVE)
1 INSTR PSWA addr
TERM NOPRINT NORUN SIM
SKIP 00000 PASS 00000 STOP 00000 STEP 00000
CMD * FUNC=SLSBINIT OFFSET=00000000
2 INSTR PSWA addr-addr
TERM NOPRINT NORUN SIM
SKIP 00000 PASS 00000 STOP 00000 STEP 00000
CMD * FUNC=SLKODE OFFSET=00000054