Filter
Top Products
332 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
VOLIST
optionally specifies that the utility produce a volume report. This parameter is used
in combination with VOLDATA so that both a flat file and a volume report can be
created. Normally, you would not specify VOLIST without also designating
VOLDATA.
If VOLIST, VOLDATA, and CDSDATA (see below) are specified, a volume
report is created and a single flat file is produced that contains volume and
non-volume information.
Note: VOLIST is not available if Volume Report is running under SCP.
CDSDATA
optionally specifies that the Volume Report utility is to produce non-volume CDS
data for the data set defined by the SLSCDATA DD statement (refer to
“SLSCDATA” on page 333. CDSDATA is independent of VOLDATA and does not
keep a volume report from being produced.
Note: CDSDATA is not available if Volume Report is running under SCP.
SUMMary
optionally specifies that the utility provide totals of volume attributes on an LSM and
ACS basis, and/or subpool data on an ACS or LSM basis. Totals are affected by the
use of limiting parameters such as ‘‘ACS’’ (and possibly ‘‘LSM’’),
‘‘VOLser’’/‘‘VOLume,’’ and ‘‘INCLude’’ and/or ‘‘EXCLude.’’
If both TOTal and SUBpool are specified, both reports are provided. The time and
date displayed in the header for the Summary Report(s) are the same as the Volume
Report Listing header.
Note: SUMMary is not available if Volume Report is running under SCP.
TOTal
specifies that totals of scratch, selected, errant, available cells, and external
label status types be provided on an LSM, ACS, and library basis in the report.
The totals are listed on a separate listing, on a new page from the Volume
Report Listing and the Control Card Listing. An example depicting the totals is
in Figure 21 on page 343.
SUBpool
specifies that subpool totals be provided on an LSM, ACS, and library basis in
the report.
Subpool information must be provided through PARMLIB SCRPOol control
statements (refer to “Scratch Subpool Control Statement” on page 100). These
statements are contained in a data set pointed to by the SLSSCRPL DD
statement (refer to “JCL/Parameter File Requirements” on page 333).
Volume Report