Filter
Top Products
108 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
LMUPATH Control Statement
The LMUPATH control statement allows users to define network LMU attachments.
LMUPATH statements are read from the definition data set specified by the LMUPDEF
command. The LMUPATH statement must be placed in the definition data set; it cannot be
issued as an operator command.
Note: Users can find additional important TCP/IP-related information by referring to
“Dynamic LMU Connection” on page 70. To display the LMUPDEF data set, refer to
Display LMUPDEF in the HSC Operator’s Guide.
LMUPATH Usage
LMUPATH statements define the TCP/IP addresses used to communicate between an
HSC on a host and the LMU for a specific ACS. Up to two addresses can be specified for
each ACS, however, a second address indicates a dual LMU environment.
Note: TCP/IP must be initialized prior to bringing the HSC to the full service level.
Syntax
Control Statement Name
LMUPATH
initiates the LMUPATH control statement.
Parameters
ACS
specifies the ACS name.
aa
specifies the hexadecimal ACSid value (00 through FF) to identify the LMU
used to communicate with an HSC.
,
ACS(aa) LMUADDR(LMUPATH
lmu_hostname
nnn.nnn.nnn.nnn
)
LMUPATH