Filter
Top Products
Chapter 3. HSC Control Statements and HSC Start Procedure 101
1st ed., 6/30/04 - 312579601
RANGE
range specifies the volume serial numbers which the subpool represents. Range start
and end values are separated by a single dash (-). Multiple ranges may be specified
separating each range by commas.
Notes:
1. The range of volume serial numbers must be unique for each subpool; that is, a
volume serial number cannot be used in more than one subpool range.
2. Make sure when you are coding multiple ranges of tapes that you do not specify
the RANGE parameter on different SCRPOol control statements. If more than
one SCRPOol statement has been specified, the HSC reads only the last
RANGE setting it encounters and loads only that range. All other ranges are
ignored.
StorageTek recommends that you specify multiple ranges, separated by
commas, on one SCRPOol control statement if possible.
LABEL
type specifies the label type associated with the applicable subpool. Types include:
SL
standard label
NL
no label
AL
ANSI label
NSL
nonstandard label
HOSTID
optionally, defines the hosts that are valid for this subpool. Multiple host-lists may be
specified, separating each host-list value with a comma. Default HOSTID is ALL. If
you need to define the same subpool name on some but not all hosts, you may
duplicate the SCRPOol statement changing the HOSTID parameter as necessary (see
examples). Optionally, you may use separate PARMLIB data sets for each host, but
this is not recommended.
SCRPOol