Filter
Top Products
Chapter 3. HSC Control Statements and HSC Start Procedure 147
1st ed., 6/30/04 - 312579601
Parameters
SERial
specifies one or more volume serial numbers (VOLSERs) to which this definition
applies.
volser or vol-range or vol-list
identifies a single VOLSER, a VOLSER range, or a list of VOLSERs and/or
VOLSER ranges in any combination. This parameter may include the following
wildcard characters:
% or ? any single non-blank character.
* any character string (length 0 to 6).
The wildcard characters shown above may not be used in a range.
Notes:
1. On a single VOLATTR statement, all volumes specified in a list or range
must be the same media type (e.g., a Standard cartridge cannot be included
in a range of VOLSERs that also contains an ECART or DD3A cartridge).
2. If a given VOLSER is not included in any VOLATTR statement, the
MEDia value defaults to Standard; thus, RECtech defaults to LONGitud.
MEDia
optionally, specifies the type of media (cartridge) for the VOLSER designated in the
SERial parameter.
Note: The SL8500 library supports only the T9x40 (9840/T9840B/T9840C
and T9940A/T9940B) media types.
Only specific media types can be entered. Generic media types, that is, LONGItud
and HELical, cannot be specified. Refer to the syntax for this control statement to see
the parameters available to you.
VOLATTR