Filter
Top Products
104 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
Options Offered by Definition Data Set Control Statements
The following definition data set control statements are included in this chapter:
OPTion TITLE
This control statement allows you to specify a string that identifies a definition data
set. Refer to “OPTion TITLE Control Statement” on page 113 for control statement
syntax, parameter information, and example statements.
LMU Path
The LMUPATH control statement defines network LMU attachments. Refer to
“LMUPATH Control Statement” on page 108 for control statement syntax,
parameter information, and example statements.
LMU Parameter Definition
The LMUPDEF command and control statement identifies the definition data set
where network LMU network attachment statements reside (see LMUPATH).
LMUPDEF can be issued either in PARMLIB or as an operator command. Refer to
“LMUPDEF Command and Control Statement” on page 110 for control statement
syntax, parameter information, and example statements.
Scratch Subpool Parameter Statement Definition
The SCRPDEF command and control statement identifies the definition data set
where scratch subpool parameter statements reside (see Scratch Subpool Control
Statement). SCRPDEF can be issued either in PARMLIB or as an operator
command. Refer to “Scratch Subpool Definition (SCRPDEF) Command and Control
Statement” on page 115 for control statement syntax, parameter information, and
example statements.
Tape Request
The TAPEREQ control statement specifies tape request attributes. Refer to “Tape
Request (TAPEREQ) Control Statement” on page 118 for control statement syntax,
parameter information, and example statements.
Tape Request Definition
The TREQDEF command and control statement identifies the definition data set
where the tape request attributes reside (see TAPEREQ). TREQDEF can be issued
either in PARMLIB or as an operator command. Refer to “Tape Request Definition
(TREQDEF) Command and Control Statement” on page 133 for control statement
syntax, parameter information, and example statements.
Unit Attribute
The UNITATTR control statement specifies unit attributes. Refer to “Unit Attribute
(UNITATTR) Control Statement” on page 136 for control statement syntax,
parameter information, and example statements.
Unit Attribute Definition
The UNITDEF command and control statement identifies the definition data set
where the unit attributes can be found (see UNITATTR). UNITDEF can be issued
either in PARMLIB or as an operator command. Refer to “Unit Attribute Definition