Filter
Top Products
Chapter 4. Utility Functions 245
1st ed., 6/30/04 - 312579601
STK2PA
indicates a T9940A transport.
STK2PA34
indicates a 3490E-image T9940A transport.
STK2PA35
indicates a 3590-image T9940A transport.
STK2PB
indicates a T9940B transport.
STK2PB34
indicates a 3490E-image T9940B transport.
STK2PB35
indicates a 3590-image T9940B transport.
CAP
specifies which Cartridge Access Port(s) is being used for the operation.
This utility ejects scratch volumes to the specified CAP(s) only. EJECt searches for
scratch volumes only in the LSMs that contain the specified CAP(s).
Note: If a CAP has not been specified, EJECt determines the CAP to use based
upon the CAPPref command setting (refer to ‘‘CAP Preference (CAPPref)
Command and Control Statement’’ in the HSC Operator’s Guide).
If a CAP preference has not been specified, the HSC displays a message and waits
until the user enters a CAPPref value. Pass-thrus can be made to CAPs specified by
CAPPref.
(cap-list)
cap-list identifies the Cartridge Access Port(s). The cap-list requires
explicitly specified CAPids separated by commas. A CAPid range is not
allowed.
If more than one CAPid is specified, the elements must be separated by
blanks or commas, and the entire list must be enclosed in parentheses. If
no CAP is specified, one is chosen in each ACS.
The format for cap-id is AA:LL:CC where AA is the ACS number
(hexadecimal 00-FF), LL is the LSM number (hexadecimal 00-17), and
CC is the CAP number.
Allowable values for CC are:
00
• For 4410 and 9310 LSMs, standard 21-cell CAP or the right-hand 40-cell
enhanced CAP
Eject Cartridge