Filter
Top Products
Chapter 4. Utility Functions 273
1st ed., 6/30/04 - 312579601
Note: Virtual device addresses may need to be changed in ACS SYSPROF
when adding new data set names.
e. Copy the updated SYSPROF to the RUN-disk.
COPY ACS SYSPROF A ACS SYSPROF B (REPLACE
f. Allocate the new data sets using SLIMDISK.
Note: Review all the DASD considerations before allocating data sets. Refer to
‘‘Calculating DASD Space’’ in the HSC Installation Guide.
g. Issue the following command to create a job to initialize the new library data
sets:
EXEC ACS UTIL SLICREAT (NOSEND
h. Verify that the information is correct and file the job.
Note: Be sure to add /FILE statements for all journals for all hosts.
i. Issue the following command to create a new production startup job file:
EXEC ACS UTIL HSCINIT (NOSEND
j. Verify that the information is correct and file the job. Modify the data set,
volume, and unit information as necessary.
k. Copy the new startup job file to the STKACS ACS191-disk.
COPY HSCINIT SLKJCL A HSCINIT SLKJCL C
l. Enter the following commands on STKACS. Then, reaccess the RUN-disk to
access the new LIBGEN and SYSPROF, load the LIBGEN into memory, and
start the SCP.
ACCESS 191 A
ACCESS 192 D
NUCXLOAD libgen
ACS INIT (NOJOB
libgen is the name of the new LIBGEN module created in step 4 on page 259.
m.Issue the following command from the MAINTSTK machine:
EXEC ACS SUBMIT SLICREAT SLKJCL
Wait for the job to complete.
n. XEDIT ACS SYSPROF A to restore the SLSCNTL, SLSCNTL2, and
SLSSTBY DSNs to the old names by removing the comments from the old
Reconfiguration