Filter
Top Products
GFK-0825F Chapter 5 Station Configuration 5-23
5
Module Fault Reportin
g
After zooming in from the reference address configuration screen, configure whether or not the Bus
Interface Unit will report faults from the module to the network controller.
S1 Report Faults
prv > tgl entr
YES
Use the F1 (previous) key if you want to return to the previous screen.
1. If you want to change the current selection, press F3 (tgl).
2. Use the F4 (entr) key to save the selection.
3. Press F2 to go to the next screen.
Default Inputs or Hold Last State
Next, configure what type of data the Bus Interface Unit should provide to the BIU internal table if
it stops receiving actual input data from the module.
S1 Hld Lst State
< > tgl entr
NO
1. Select YES if the Bus Interface Unit should hold inputs in their last states and supply that data
to the BIU internal table.
Select NO if the Bus Interface Unit should default all the module's inputs to 0 and supply that
data to the BIU internal table instead.
2. Use the F4 (entr) key to save the selection.
3. Press F2 ( > ) to return to the original slot configuration screen.