Filter
Top Products
GFK-0825F Chapter 6 Diagnostics and Fault Clearing 6-3
6
Display and Clear Faults from a Genius Hand-held Monitor
A Genius Hand-held Monitor can display faults from a Bus Interface Unit while attached anywhere
on the Genius bus.
1. From the HHM Main Menu shown below, display the HHM's special set of menus for the Bus
Interface Unit.
F1:HHM UTILITIES
F2:ANALYZE
F3:CONFIGURATION
F4:DEVICE MEMORY
A. If the Bus Interface Unit is the currently-selected device, press either F3 (Configuration)
or F2 (analyze) twice.
B. If the Bus Interface Unit is NOT the currently-selected device:
•
Select F2 (analyze) then F3 (Block/Bus Status).
•
Press the F1 (nxt) or F2 (prev) key repeatedly until you reach the serial bus address of
the Bus Interface Unit. Press F3 to make the Bus Interface Unit the active device.
Then, press the keypad Menu key, followed by F2 (Monitor/Control Reference).
The HHM's Main Menu for the Bus Interface Unit appears:
F1 Monitor
F2 Configuration
2. Select F1 (monitor) to display this menu:
F1 Monitor I/O
F2:Faults
F3 Previous Menu
3. Select F2 (faults) to display fault information for the Bus Interface Unit and its modules.