Filter
Top Products
Index
GFK-0825F Index Index-5
Analog output module, 5-39
example, A-5
in millivolts or microamps, A-1
measuring, A-4
Scan times, 4-7
Selective sweep, 4-4
Serial Bus Address
assigning to new BIU, 5-4
changing with the HHM, 5-7
configuring, 5-2
Series 90-70 PLC
handles input data from BIU, 4-10
Series 90-70 PLC
Bus Controller version, 1-9
configuration special instructions, 5-2
CPU version required for Field Control, 1-9
Series Five PLC
Bus Controller version, 1-9
fault clearing, 6-5
handles input data from BIU, 4-10
monitoring I/O data, 7-6
reference address, 5-9
version required, 1-9
Series Six PLC
Bus Controller version, 1-9
fault clearing, 6-5
handles input data from BIU, 4-10
monitoring I/O data, 7-6
reference address, 5-9
version required, 1-9
Set BIU Mode datagram, 8-29
Set Micro Field Processor Mode datagram,
8-29
Signal wiring, 3-3, C-1
Slot number, 5-20
Specifications. See individual I/O module
datasheets
electrical, 2-9
environmental, 1-5
noise, 1-5
temperature, 1-5
vibration, 1-5
Standards, 1-5
Suppression
at the communications line, B-2
Surge suppressors, C-11
Synchronization, 4-14
Synchronization module, 4-5, 4-6
Synchronous operation of BIU and MFP, 4-16
T
Temperature specifications, 1-5
Terminal Block
installing on DIN rail, 3-7
removing from DIN rail, 3-7
Terminating the bus, 3-11, C-4
Thermocouple Input module
Alarm Limits, 5-78
Channel Active, 5-76
configuration steps, 5-72
data defaults, 5-74
I/O references, 5-72
Line frequency, 5-75
Offset, 5-80
Open Thermocouple diagnostic, 5-75
Range Type, 5-77
Reference Junction Compensation, 5-79
Reference Junction value, 5-79
Thermocouple type, 5-77
Units, 5-76
Thermocouple type
configuring, 5-77
Throughput, 4-13
Timing, 4-12
U
Units
RTD module, 5-68
Thermocouple module, 5-76
V
Vibration specification, 1-5
Voltage attenuation, C-7
W
Wire type for RTD module, 5-69
Wiring guidelines, 3-3, C-1
Write Configuration datagram, 8-8
Write Map datagram, 8-4