Filter
Top Products
5-10 Field Control™ Genius® Bus Interface Unit User’s Manual
–
October 1999 GFK-0825F
5
Configure Fault Reporting
On the next screen, select whether or not the Bus Interface Unit will perform any fault reporting.
Report Faults
YES
< > tgl entr
If you want to set up partial fault reporting for the station, you can set fault reporting to YES here
but inhibit fault reporting for some or all individual modules in the station. Instructions for setting
up or inhibiting fault reporting for individual modules are included in the module configuration
portion of this chapter.
1. If you want to go to the next screen without making a change, press F2 ( > ).
If the Report Faults selection should be changed, press F3 (tgl).
2. Press F4 (entr) to save the change and go to the next menu.