Filter
Top Products
GFK-0825F Chapter 5 Station Configuration 5-5
5
Configure the Bus Interface Unit
From the HHM's Main Menu:
F1:HHM UTILITIES
F2:ANALYZE
F3:CONFIGURATION
F4:DEVICE MEMORY
Press F2 twice to display the HHM's special set of menus for the Bus Interface Unit. (To display
these menus, a serial bus address must have been configured for the Bus Interface Unit on the
Program Block ID screen). An overview of these menus is shown on the next page.
This is the HHM's Main Menu for Field Control:
F1 Monitor
F2 Configuration
From this menu, press F2 (Configuration). This menu appears:
F1 Genius Config
F2 Module Config
More
From this menu, you can:
Press F1 to configure the Genius Bus Interface Unit. Instructions begin on the next page.
Press F2 to configure the individual modules in the station. Instructions begin on page 5-23.
Press F4 to display the next configuration screen:
F1 Grp Data Move
F2 Previous Menu
More