Filter
Top Products
GFK-0825F 5-1
Station Configuration
This chapter explains how to configure a Bus Interface Unit and the I/O modules in a station using
a Hand-held Monitor. HHM version 4.6 (IC660HHM501J) or later is required. Note that the BIU
and I/O modules can also be configured via datagrams from the host. Datagram formats are
detailed in chapter 8.
Setting up the serial bus address and baud rate
Special instructions for Series 90-70 PLC systems
Set up the Hand-held Monitor
Display the configuration menu
Genius configuration
• Select the baud rate
• Select the serial bus address for the Bus Interface Unit
• Select a Series Six or Series Five PLC reference address
• Configure fault reporting
• Configure Genius bus redundancy
• Configure CPU redundancy
• Select configuration protection
• Reference address configuration
Module Configuration
• Read a module configuration
• Delete or edit an existing module configuration
• Select a module type
• Configure specific I/O modules.
• Configure a Micro Field Processor
For Additional Information, Also See:
The Hand-held Monitor datasheet for basic operating instructions.
The programming/setup instructions for the system host. The instructions in this chapter are for
local configuration of the BIU and the modules in the I/O station. The system host must also be
configured appropriately to exchange information with the BIU. If the host is a Series 90-70 PLC,
with Logicmaster 90 software release 5.0 or earlier the Genius Bus Interface Unit must be
configured as a "Generic I/O" device.
5
Chapter