Filter
Top Products
5-48 Field Control™ Genius® Bus Interface Unit User’s Manual
–
October 1999 GFK-0825F
5
Configure an 8-Point Grouped Analog Voltage Input Module
When you select “Read” from the empty slot HHM screen, this module screen appears:
S : 2 ALG2 8 1 1 . 0
< > del zoom
Assign I/O References for the Module
When you “zoom" into the module's slot, a screen like this appears:
Default data len
g
th
S: 2 AI *AI : 008
AI01970-01977
< > chg ent r
Default BIU data t
yp
e
Next available reference
This screen shows the default table and length, and the next available reference address
in that table for that reference parameter. The length is displayed in units that are
appropriate for that data type (AI and AQ are in words, Q and I are in bits). The asterisk
indicates that this reference has not yet been defined.
If the present selection is acceptable, press F4 (enter) to accept it. The asterisk will
disappear.
If you prefer to change the BIU table mapping, length, or reference value, press F3
(change).
S : 2 AI AI
Sel ect t abl e
tgl entr
From this screen, you can display the other BIU data types by pressing F3 (toggle).
Press F4 (enter) when the desired data type is displayed.
S : 2 AI AI : 0 0 8
Select length
clr entr
If you want to enter a different length for the displayed data type, press F3 (clear) to
clear the length field. Enter the new length from the keypad. If you enter an invalid
length, the HHM prompts
:
BAD LENGTH ERR
S1 CH 1
ACTIVE
S1 CH1 RANGE
-10V to +10V
S1 CH1 SPAN LO
-10000
-10000
S1 CH1 ENG HI
10000
S1 CH1 AL HI
10000
S1 CH1 SPAN HI
10000
S1 CH1 ALRM LO
-10000
F4, F2
F4, F2
F2
F1
S1 Network->%Q
DEFAULT ZERO
F2
F1
F2
F1
F1, F2, select
channel
F4
F2
F1
F2
F1
F2
F1
F2 F1
F2
F1
F2
F1
F2
F1
F2
F1
Repeat for other
channels
F2
S1 FILTERING
20MS
S1 LINE FREQ
60 HZ
S1: Q *Q008
Q00001-00008
S1 Module-> %I
DEFAULT ZERO
S1: I * I:040
I00001-00040
S1 Module-> %AI
DEFAULT ZERO
S1: ALG281: 1.0
F4
S1: AI *AI008
AI00001-00008
F4, F2
S1 CH1 ENG LO
S1 CH 1 CONFIG
S1 Network
-
>%Q
DEFAULT ZERO