Filter
Top Products
8-16 Field Control™ Genius® Bus Interface Unit User’s Manual
–
October 1999 GFK-0825F
8
Conventional Analog Output Modules Configuration Data Format
Specify the actual slot number and a length of 62.
The reference address is the location in the BIU's I, Q, AI, or AQ memory that is used by the
module's data. Specify only one address, typically in the analog output (AQ) table. Set the other
address selection bytes to all zeros.
unlabelled bits must be 0
Bytes 0 to 3 must be: 33 hex, 0,0,0
76543210
Byte 12
Output Default or Hold Last Value
(0 = default, 1 = hold last value)
76543210
Byte 13
reserved
(
must be 0
)
7 6 543210
Fault Reportin
g
(
0 = enabled, 1 = disabled
)
Channel Active (0 = active, 1 = inactive)
unlabelled bits must be 0
Bytes 14, 26, 38, 50 (see below)
Range: 00 = 0mA to 20mA
01 = 4mA to 20mA
10 = 0V to 10V
11 = -10V to +10V
76543210
76543210
Byte 4
LSB
MSB
Byte 5
I Reference Address or all zeros
76543210
76543210
Byte 6 LSB
MSB
Byte 7
76543210
76543210
Byte 8
LSB
MSB
Byte 9
76543210
76543210
Byte 10 LSB
MSB
Byte 11
Q Reference Address or all zeros
AI Reference Address or all zeros
AQ Reference Address or all zeros