Filter
Top Products
GFK-0825F Chapter 5 Station Configuration 5-21
5
Configuration with No Module Present
If the module is not present in the selected slot, press the F3 (tgl) key to specify a module type. The
following screen will appear:
OR
Generic I/O
S:1 I/O Type ?
tgl entr
Special I/O
S:1 I/O Type ?
tgl entr
1. Press F3 (tgl) to select Generic I/O or Special I/O. Then press F4 (entr).
2. Use the F3 (tgl) key again to go through the module names listed below. When the correct
module name appears, press F4 (entr).
3. Complete the module configuration as described in this chapter.
Read a Module Identification with the Module Present
If there is a module in the currently-selected slot, pressing F4 (read) from the "empty slot" screen
brings up the module's identification screen.
Example screen for a non-intelligent module (to accept the currently-displayed module type, press
F4 (entr) then complete the module configuration as described in this chapter):
R0:S1 Mod type?
tgl entr
Module
t
y
pe
Discrete Out 16
If you want to change the module type displayed
,
press F3 (tgl) to see the other module types.
Example screen for an intelligent module (press F4 (zoom) to configure the I/O references as
described in this chapter). You cannot change the module type of an intelligent module.
S:5 ALG630 1.0
< > tgl zoom
Module type
and version
Delete an Existing Module Configuration
To delete the configuration of the module in the present slot, press F3 (delete) then F4 (enter). Note
that this removes the entire module configuration.