Filter
Top Products
GFK-0825F Chapter 5 Station Configuration 5-65
5
You can press F4 (enter) to accept this value, or F3 (clear) then enter a new value from the keypad.
Press the F4 (enter) key after entering a new offset.
S:4 AI AI:004
Ref Addr 01896
clr entr
Use the F2 ( > ) key to display the screen for the module's discrete input diagnostic data.
S:4 I * I:032
I01817-01904
< > chg entr
You can edit this screen or accept it using the F4 (enter) key. After you press the Enter key, the
asterisk disappears to show that the current values have been saved. Next, press F2 to go to the
screen that shows the module's Q references, which are for fault clearing.
S:4 Q * Q:008
Q01817-01832
< > chg entr
You can also edit this screen. Use the F4 (enter key) to save the selections. Press F2 to continue to
the next item. The next screen displays AQ references for the module. Enter a length of 0. Use
the F4 (enter) key to save and continue.
S:4 AQ AQ:004
AQ01057-01060
< > chg entr
All required references for the module must be entered. You can give a reference parameter a
length of zero if you do not want to map the data to the BIU. If you attempt to back out before the
references are all configured, the HHM displays the following screen:
Cfg Incomplete
Clear Slot?
yes no
If you exit from this display, the references you have configured are not saved.