Filter
Top Products
GFK-0825F Chapter 5 Station Configuration 5-85
5
Configure Local Default Outputs
Next, select the default output mode used for all channels in the event of a local (module) failure or
reset.
This is not the same as the data defaults described on the previous page, which are for the BIU.
The choices for local default output are:
A. ZERO: The output of each channel goes to 0mV in the event of a local failure or reset.
B. HOLD LAST: The output of each channel is held at the last value latched by the D/A
converters in the event of a local failure or reset (provided the appropriate user power supply is
present).
ZERO
S:1 LOC DEF OUT
< > tgl entr
1. If you want to change the displayed selection, press F3 (Tgl).
2. Use the F4 (entr) key to save the selection.
3. Press F2 ( > ) to go to the next screen.