Filter
Top Products
D-1
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
APPENDIX
D
CLI Error Messages
This appendix lists the CLI error messages and CLI validation error messages. It contains the following
sections:
• CLI Error Messages, page D-1
• CLI Validation Error Messages, page D-5
CLI Error Messages
Table D-1 describes CLI error messages.
Table D-1 CLI Error Messages
Error Message Reason Command
getVirtualSensorStatistics :
Analysis Engine is busy
Analysis Engine is busy because the
virtual sensor has not finished
initializing.
show statistics
virtual-sensor
getVirtualSensorStatistics :
Analysis Engine is busy
rebuilding regex tables.
This may take a while.
Analysis Engine is busy building
cache files immediately after the
sensor has been imaged.
show statistics
virtual-sensor
editConfigDeltaSignatureDefi
nition : Analysis Engine is
busy rebuilding regex
tables. This may take a
while.
Analysis Engine is busy building
cache files immediately after the
sensor has been imaged.
service
signature-definition
Invalid command received.
The .conf file and code are out of
synchronization, which should never
occur in the field.
All commands
Invalid port number was
entered.
An out-of-range port number was
entered in URI.
copy, upgrade,
show tech-support
Invalid scheme was entered.
Internal tables are out of
synchronization, which should never
occur in the field.
copy, upgrade,
show tech-support
Unknown scheme was entered.
An invalid scheme was entered in
URI.
copy, upgrade,
show tech-support