Filter
Top Products
17-49
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 17 Administrative Tasks for the Sensor
Displaying Hardware Inventory
Step 3 Show the history of the commands you have used in network access mode, for example.
sensor# configure terminal
sensor (config)# service network-access
sensor (config-net)# show history
show settings
show settings terse
show settings | include profile-name|ip-address
exit
show history
sensor (config-net)#
Displaying Hardware Inventory
Use the show inventory command to display PEP information. This command displays the UDI
information that consists of the PID, the VID, and the SN of your sensor. If yoru sensor supports
SFP/SFP+ modules and Regex accelerator cards, they are also displayed. PEP information provides an
easy way to obtain the hardware version and serial number through the CLI.
To display PEP information, follow these steps:
Step 1 Log in to the CLI.
Step 2 Display the PEP information. You can use this information when dealing with TAC.
sensor# show inventory
Name: "Chassis", DESCR: "IPS 4255 Intrusion Prevention Sensor"
PID: IPS-4255-K9, VID: V01 , SN: JAB0815R017
Name: "Power Supply", DESCR: ""
PID: ASA-180W-PWR-AC, VID: V01 , SN: 123456789AB
sensor#
sensor# show inventory
Name: "Module", DESCR: "ASA 5500 Series Security Services Module-20"
PID: ASA-SSM-20, VID: V01 , SN: JAB0815R036
sensor#
sensor# show inventory
Name: "Chassis", DESCR: "IPS 4240 Appliance Sensor"
PID: IPS-4240-K9, VID: V01 , SN: P3000000653
sensor#
sensor# show inventory
Name: `Chassis`, DESCR: `IPS 4345 with SW, 8 GE Data + 1 GE Mgmt, AC Power`
PID: IPS-4345-K9 , VID: V01 , SN: FGL162740GG
Name: `RegexAccelerator/0`, DESCR: `LCPX8640 (humphrey)`
PID: FCH162177B2 , VID: 33554537, SN: LXXXXXYYYY
Name: `HwBypassCard`, DESCR: `Hardware bypass card`
PID: PE2G4BPFi35CS , VID: 3.0, SN: , Port0MAC: 00E0ED22FD92
Name: `power supply 1`, DESCR: `IPS4345 AC Power Supply `