Filter
Top Products
19-16
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 19 Configuring the ASA 5500-X IPS SSP
New and Modified Commands
failover
failover lan unit secondary
failover lan interface folink GigabitEthernet0/7
failover interface ip folink 172.27.48.1 255.255.255.0 standby 172.27.48.2
New and Modified Commands
This section describes the new and modified Cisco ASA commands that support the
ASA 5500-X IPS SSP and are used to configure the ASA 5500-X IPS SSP.
Note All other Cisco ASA CLI commands are documented in the Cisco Security Appliance Command
Reference on Cisco.com at
http://www.cisco.com/en/US/products/ps6120/prod_command_reference_list.html.
This section contains the following topic:
• allocate-ips, page 19-16
allocate-ips
To allocate an IPS virtual sensor to a security context if you have the ASA 5500-X IPS SSP installed,
use the allocate-ips command in context configuration mode. To remove a virtual sensor from a context,
use the no form of this command.
allocate-ips sensor_name [mapped_name] [default]
no allocate-ips sensor_name [mapped_name] [default]
Syntax Description default (Optional) Sets one sensor per context as the default sensor; if the context
configuration does not specify a sensor name, the context uses this default
sensor. You can only configure one default sensor per context. If you want to
change the default sensor, enter the no allocate-ips sensor_name command
to remove the current default sensor before you allocate a new default sensor.
If you do not specify a sensor as the default, and the context configuration
does not include a sensor name, then traffic uses the default sensor on the
ASA 5500-X IPS SSP.