Filter
Top Products
5-18
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 5 Configuring Interfaces
Configuring Physical Interfaces
duplex: full default: auto
speed: 1000 default: auto
alt-tcp-reset-interface
-----------------------------------------------
interface-name: GigabitEthernet2/0
-----------------------------------------------
subinterface-type
-----------------------------------------------
none
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
sensor(config-int-phy)#
Step 12 Remove TCP resets from an interface.
sensor(config-int-phy)# alt-tcp-reset-interface none
Step 13 Verify the settings.
sensor(config-int-phy)# show settings
<protected entry>
name: GigabitEthernet0/0
-----------------------------------------------
media-type: tx <protected>
description: <defaulted>
admin-state: disabled <protected>
duplex: auto <defaulted>
speed: auto <defaulted>
alt-tcp-reset-interface
-----------------------------------------------
none
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
sensor(config-int-phy)#
Step 14 Exit interface submode.
sensor(config-int-phy)# exit
sensor(config-int)# exit
Apply Changes:?[yes]:
Step 15 Press Enter to apply the changes or enter no to discard them.
For More Information
• For a list of possible interfaces for your sensor, see Interface Support, page 5-7.
• For the procedure for sending traffic to the ASA 5500 AIP SSM, see Sending Traffic to the ASA
5500 AIP SSM, page 18-10.
• For the procedure for sending traffic to the ASA 5500-X IPS SSP, see Creating Virtual Sensors for
the ASA 5500-X IPS SSP, page 19-3.
• For the procedure for sending traffic to the ASA 5585-X IPS SSP, see Creating Virtual Sensors for
the ASA 5585-X IPS SSP, page 20-4.
• For more information on the alternate TCP reset interface, see Understanding Alternate TCP Reset
Interfaces, page 5-5 and Designating the Alternate TCP Reset Interface, page 5-6.