Filter
Top Products
4-37
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 4 Setting Up the Sensor
Configuring Time
• ASA 5500 AIP SSM
• ASA 5500-X IPS SSP
• ASA 5585-X IPS SSP
To manually set the clock on the appliance, follow these steps:
Step 1 Log in to the CLI using an account with administrator privileges.
Step 2 Set the clock manually.
sensor# clock set 13:21 Mar 29 2011
Note The time format is 24-hour time.
Configuring Recurring Summertime Settings
Note Summertime is a term for daylight saving time.
Use the summertime-option recurring command to configure the sensor to switch to summertime
settings on a recurring basis. The default is recurring.
To configure the sensor to switch to summertime settings on a recurring basis, follow these steps:
Step 1 Log in to the sensor using an account with administrator privileges.
Step 2 Enter summertime recurring submode.
sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# summertime-option recurring
Step 3 Enter start summertime submode.
sensor(config-hos-rec)# start-summertime
Step 4 Configure the start summertime parameters:
a. Enter the day of the week you want to start summertime settings.
sensor(config-hos-rec-sta)# day-of-week monday
b. Enter the month you want to start summertime settings.
sensor(config-hos-rec-sta)# month april
c. Enter the time of day you want to start summertime settings. The format is hh:mm:ss.
sensor(config-hos-rec-sta)# time-of-day 12:00:00
d. Enter the week of the month you want to start summertime settings. The values are first through
fifth, or last.
sensor(config-hos-rec-sta)# week-of-month first