Filter
Top Products
3-8
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 3 Initializing the Sensor
Advanced Setup
day-of-week sunday
time-of-day 02:00:00
exit
end-summertime
month november
week-of-month first
day-of-week sunday
time-of-day 02:00:00
exit
exit
ntp-option enabled
ntp-keys 1 md5-key 8675309
ntp-servers 10.10.1.2 key-id 1
exit
service global-correlation
network-participation full
exit
[0] Go to the command prompt without saving this config.
[1] Return to setup without saving this config.
[2] Save this configuration and exit setup.
[3] Continue to Advanced setup.
Step 11 Enter 2 to save the configuration (or 3 to continue with advanced setup using the CLI).
Enter your selection[2]: 2
Configuration Saved.
Step 12 If you changed the time setting, enter yes to reboot the sensor.
For More Information
For the procedure for obtaining the most recent IPS software, see Obtaining Cisco IPS Software,
page 21-1.
Advanced Setup
This section describes how to continue with Advanced Setup in the CLI for the various Cisco IPS
platforms. It contains the following sections:
• Advanced Setup for the Appliance, page 3-8
• Advanced Setup for the ASA 5500 AIP SSM, page 3-14
• Advanced Setup for the ASA 5500-X IPS SSP, page 3-18
• Advanced Setup for the ASA 5585-X IPS SSP, page 3-21
Advanced Setup for the Appliance
Note The currently supported Cisco IPS appliances are the IPS 4240, IPS 4255, and IPS 4260 [IPS 7.1(5) and
later], IPS 4270-20 [IPS 7.1(3) and later], IPS 4345 and IPS 4360 [IPS 7.1(3) and later], and IPS 4510
and IPS 4520 [IPS 7.1(4) and later].