Filter
Top Products
22-32
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 22 Upgrading, Downgrading, and Installing System Images
Installing System Images
1 Up Up
asa#
Note The Status field in the output indicates the operational status of the ASA 5500-X IPS SSP. An
ASA 5500-X IPS SSP operating normally shows a status of “Up.” While the adaptive security
appliance transfers an application image to the ASA 5500-X IPS SSP, the Status field in the
output reads “Recover.” When the adaptive security appliance completes the image transfer and
restarts the ASA 5500-X IPS SSP, the newly transferred image is running.
Note To debug any errors that may happen in the recovery process, use the debug module-boot
command to enable debugging of the system reimaging process.
Step 8 Session to the ASA 5500-X IPS SSP and initialize it with the setup command.
For More Information
• For more information about TFTP servers, see TFTP Servers, page 22-14.
• For a list of the specific system image files, see IPS 7.1 Upgrade Files, page 22-4.
• For the procedure for initializing the ASA 5500-X IPS SSP, see Advanced Setup for the ASA
5500-X IPS SSP, page 3-18.
Installing the System Image for the ASA 5585-X IPS SSP
This section describes how to install the ASA 5585-X IPS SSP system image using the hw-module
command or ROMMON, and contains the following topics:
• Installing the ASA 5585-X IPS SSP System Image Using the hw-module Command, page 22-32
• Installing the ASA 5585-X IPS SSP System Image Using ROMMON, page 22-35
Installing the ASA 5585-X IPS SSP System Image Using the hw-module Command
Note Be sure the TFTP server that you specify can transfer files up to 60 MB in size.
Note This process can take approximately 15 minutes to complete, depending on your network and the size
of the image.
Note The CLI output is an example of what your configuration may look like. It will not match exactly due to
the optional setup choices, sensor model, and IPS 7.1 version you have installed.