Filter
Top Products
22-30
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 22 Upgrading, Downgrading, and Installing System Images
Installing System Images
Step 9 Execute the recovery.
asa# hw-module module 1 recover boot
This transfers the image from the TFTP server to the ASA 5500 AIP SSM.
Step 10 Periodically check the recovery until it is complete.
Note The status reads Recovery during recovery and reads Up when reimaging is complete.
asa# show module 1
Mod Card Type Model Serial No.
--- -------------------------------------------- ------------------ -----------
0 ASA 5540 Adaptive Security Appliance ASA5540 P2B00000019
1 ASA 5500 Series Security Services Module-20 ASA-SSM-20 P1D000004F4
Mod MAC Address Range Hw Version Fw Version Sw Version
--- --------------------------------- ------------ ------------ ---------------
0 000b.fcf8.7b1c to 000b.fcf8.7b20 0.2 1.0(7)2 7.1(1)82
1 000b.fcf8.011e to 000b.fcf8.011e 0.1 1.0(7)2 5.0(0.22)S129.0
Mod Status
--- ------------------
0 Up Sys
1 Up
asa#
Note The Status field in the output indicates the operational status of the ASA 5500 AIP SSM. An
ASA 5500 AIP SSM operating normally shows a status of “Up.” While the adaptive security
appliance transfers an application image to the ASA 5500 AIP SSM, the Status field in the
output reads “Recover.” When the adaptive security appliance completes the image transfer and
restarts the ASA 5500 AIP SSM, the newly transferred image is running.
Note To debug any errors that may happen in the recovery process, use the debug module-boot
command to enable debugging of the system reimaging process.
Step 11 Session to the ASA 5500 AIP SSM and initialize it with the setup command.
For More Information
• For more information about TFTP servers, see TFTP Servers, page 22-14.
• For a list of the specific system image files, see IPS 7.1 Upgrade Files, page 22-4.
• For the procedure for initializing the ASA 5500 AIP SSM, see Advanced Setup for the ASA 5500
AIP SSM, page 3-14.