Filter
Top Products
5-29
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 5 Configuring Interfaces
Configuring Inline VLAN Pair Mode
subinterface-type
-----------------------------------------------
none
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
<protected entry>
name: Management0/0 <defaulted>
-----------------------------------------------
media-type: tx <protected>
description: <defaulted>
admin-state: disabled <protected>
duplex: auto <defaulted>
speed: auto <defaulted>
alt-tcp-reset-interface
-----------------------------------------------
none
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
subinterface-type
-----------------------------------------------
none
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
command-control: Management0/0 <protected>
inline-interfaces (min: 0, max: 999999999, current: 0)
-----------------------------------------------
-----------------------------------------------
bypass-mode: auto <defaulted>
interface-notifications
-----------------------------------------------
missed-percentage-threshold: 0 percent <defaulted>
notification-interval: 30 seconds <defaulted>
idle-interface-delay: 30 seconds <defaulted>
-----------------------------------------------
sensor(config-int)#
Step 4 If there are inline interfaces that are using this physical interface, remove them. You must also delete the
inline interface from the virtual sensor to which it is assigned.
sensor(config-int)# no inline-interfaces interface_name
Step 5 Display the list of available interfaces.
sensor(config-int)# physical-interfaces ?
GigabitEthernet0/0 GigabitEthernet0/0 physical interface.
GigabitEthernet0/1 GigabitEthernet0/1 physical interface.
GigabitEthernet0/2 GigabitEthernet0/2 physical interface.
GigabitEthernet0/3 GigabitEthernet0/3 physical interface.
Management0/0 Management0/0 physical interface.
sensor(config-int)# physical-interfaces
Step 6 Designate an interface.
sensor(config-int)# physical-interfaces GigabitEthernet0/2