Filter
Top Products
18-3
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 18 Configuring the ASA 5500 AIP SSM
Verifying ASA 5500 AIP SSM Initialization
9. Configure intrusion prevention.
10. Configure global correlation.
11. Configure global correlation.
12. Perform miscellaneous tasks to keep your ASA 5500 AIP SSM running smoothly.
13. Upgrade the IPS software with new signature updates and service packs as they become available.
14. Reimage the ASA 5500 AIP SSM when needed.
For More Information
• For the procedure for logging in to the ASA 5500 AIP SSM, see Chapter 2, “Logging In to the
Sensor.”
• For the procedure for running the setup command, see Advanced Setup for the ASA 5500 AIP SSM,
page 3-14.
• For the procedure for verifying ASA 5500 AIP SSM initialization, see Verifying ASA 5500 AIP
SSM Initialization, page 18-3.
• For the procedure for creating virtual sensors, see Creating Virtual Sensors for the ASA 5500 AIP
SSM, page 18-4.
• For the procedure for configuring ASA to send traffic to the ASA 5500 AIP SSM, see Sending
Traffic to the ASA 5500 AIP SSM, page 18-10.
• For the procedures for setting up the sensor, see Chapter 4, “Setting Up the Sensor.”
• For the procedures for configuring intrusion prevention, see Chapter 7, “Configuring Event Action
Rules,” Chapter 8, “Defining Signatures,” Chapter 9, “Configuring Anomaly Detection,”and
Chapter 14, “Configuring Attack Response Controller for Blocking and Rate Limiting.”
• For the procedures for configuring global correlation, see Chapter 10, “Configuring Global
Correlation.”
• For the procedures for keeping your ASA 5500 AIP SSM running smoothly, see Chapter 17,
“Administrative Tasks for the Sensor.”
• For more information on how to obtain Cisco IPS software, see Chapter 21, “Obtaining Software.”
• For the procedure for reimaging the ASA 5500 AIP SSM, see Installing the System Image for the
ASA 5500 AIP SSM, page 22-28.
Verifying ASA 5500 AIP SSM Initialization
You can use the show module slot details command to verify that you have initialized the
ASA 5500 AIP SSM and to verify that you have the correct software version.
To verify initialization, follow these steps:
Step 1 Log in to the adaptive security appliance.
Step 2 Obtain the details about the ASA 5500 AIP SSM.
asa# show module 1 details
ASA 5500 Series Security Services Module-10
Model: ASA-SSM-10
Hardware version: 1.0
Serial Number: JAB09370212
Firmware version: 1.0(10)0