17-38
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 17 Administrative Tasks for the Sensor
Displaying Statistics
NetDevice
Type = PIX
IP = 192.0.2.5
NATAddr = 0.0.0.0
Communications = telnet
NetDevice
Type = Cisco
IP = 192.0.2.6
NATAddr = 0.0.0.0
Communications = telnet
BlockInterface
InterfaceName = ethernet0/1
InterfaceDirection = out
InterfacePostBlock = Post_Acl_Test
BlockInterface
InterfaceName = ethernet0/1
InterfaceDirection = in
InterfacePreBlock = Pre_Acl_Test
InterfacePostBlock = Post_Acl_Test
NetDevice
Type = CAT6000_VACL
IP = 192.0.2.1
NATAddr = 0.0.0.0
Communications = telnet
BlockInterface
InterfaceName = 502
InterfacePreBlock = Pre_Acl_Test
BlockInterface
InterfaceName = 507
InterfacePostBlock = Post_Acl_Test
State
BlockEnable = true
NetDevice
IP = 192.0.2.3
AclSupport = Does not use ACLs
Version = 6.3
State = Active
Firewall-type = PIX
NetDevice
IP = 192.0.2.7
AclSupport = Does not use ACLs
Version = 7.0
State = Active
Firewall-type = ASA
NetDevice
IP = 102.0.2.8
AclSupport = Does not use ACLs
Version = 2.2
State = Active
Firewall-type = FWSM
NetDevice
IP = 192.0.2.9
AclSupport = uses Named ACLs
Version = 12.2
State = Active
NetDevice
IP = 192.0.2.10
AclSupport = Uses VACLs
Version = 8.4
State = Active
BlockedAddr
Host
IP = 203.0.113.1
Vlan =