Filter
Top Products
20-3
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 20 Configuring the ASA 5585-X IPS SSP
Verifying Initialization for the ASA 5585-X IPS SSP
9. Configure global correlation.
10. Perform miscellaneous tasks to keep your ASA 5585-X IPS SSP running smoothly.
11. Upgrade the IPS software with new signature updates and service packs as they become available.
12. Reimage the ASA 5585-X IPS SSP when needed.
For More Information
• For the procedure for logging in to the ASA 5585-X IPS SSP, see Chapter 2, “Logging In to the
Sensor.”
• For the procedure for running the setup command, see Advanced Setup for the ASA 5585-X IPS
SSP, page 3-21.
• For the procedure for verifying ASA 5585-X IPS SSP initialization, see Verifying Initialization for
the ASA 5585-X IPS SSP, page 20-3.
• For the procedure for creating virtual sensors, see Creating Virtual Sensors for the ASA 5585-X IPS
SSP, page 20-4.
• For the procedures for setting up the ASA 5585-X IPS SSP, see Chapter 4, “Setting Up the Sensor.”
• For the procedures for configuring intrusion prevention, see Chapter 7, “Configuring Event Action
Rules,” Chapter 8, “Defining Signatures,” Chapter 9, “Configuring Anomaly Detection,”and
Chapter 14, “Configuring Attack Response Controller for Blocking and Rate Limiting.”
• For the procedures for configuring global correlation, see Chapter 10, “Configuring Global
Correlation.”
• For the procedures for keeping your ASA 5585-X IPS SSP running smoothly, see Chapter 17,
“Administrative Tasks for the Sensor.”
• For more information on how to obtain Cisco IPS software, see Chapter 21, “Obtaining Software.”
• For the procedure for reimaging the ASA 5585-X IPS SSP, see Installing the System Image for the
ASA 5585-X IPS SSP, page 22-32.
Verifying Initialization for the ASA 5585-X IPS SSP
You can use the show module slot details command to verify that you have initialized the
ASA 5585-X IPS SSP and to verify that you have the correct software version.
To verify initialization, follow these steps:
Step 1 Log in to the adaptive security appliance.
Step 2 Obtain the details about the ASA 5585-X IPS SSP.
asa# show module 1 details
Getting details from the Service Module, please wait...
ASA 5585-X IPS Security Services Processor-10 with 8GE
Model: ASA5585-SSP-IPS10
Hardware version: 1.0
Serial Number: JAF1350ABSL
Firmware version: 2.0(1)3
Software version: 7.1(2)E4
MAC Address Range: 8843.e12f.5414 to 8843.e12f.541f
App. name: IPS
App. Status: Up