Filter
Top Products
19-3
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 19 Configuring the ASA 5500-X IPS SSP
Verifying Initialization for the ASA 5500-X IPS SSP
• For more information on how to obtain Cisco IPS software, see Chapter 21, “Obtaining Software.”
• For the procedure for reimaging the ASA 5500-X IPS SSP, see Installing the System Image for the
ASA 5500-X IPS SSP, page 22-31.
Verifying Initialization for the ASA 5500-X IPS SSP
You can use the show module slot details command to verify that you have initialized the
ASA 5500-X IPS SSP and to verify that you have the correct software version.
To verify initialization, follow these steps:
Step 1 Log in to the adaptive security appliance.
Step 2 Obtain the details about the ASA 5500-X IPS SSP.
asa# show module ips details
Getting details from the Service Module, please wait...
Card Type: ASA 5555-X IPS Security Services Processor
Model: ASA5555-IPS
Hardware version: N/A
Serial Number: FCH151070GW
Firmware version: N/A
Software version: 7.1(3)E4
MAC Address Range: 503d.e59c.7ca0 to 503d.e59c.7ca0
App. name: IPS
App. Status: Up
App. Status Desc: Normal Operation
App. version: 7.1(3)E4
Data Plane Status: Up
Status: Up
License: IPS Module Enabled perpetual
Mgmt IP addr: 192.0.2.2
Mgmt Network mask: 255.255.255.0
Mgmt Gateway: 192.0.2.254
Mgmt Access List: 0.0.0.0/0
Mgmt web ports: 443
Mgmt TLS enabled: true
asa#
Step 3 Confirm the information.
Creating Virtual Sensors for the ASA 5500-X IPS SSP
This section describes how to create virtual sensors on the ASA 5500-X IPS SSP, and contains the
following topics:
• The ASA 5500-X IPS SSP and Virtualization, page 19-4
• Virtual Sensor Configuration Sequence for ASA 5500-X IPS SSP, page 19-4
• Creating Virtual Sensors, page 19-4
• Assigning Virtual Sensors to Adaptive Security Appliance Contexts, page 19-6