Filter
Top Products
14-21
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 14 Configuring Attack Response Controller for Blocking and Rate Limiting
Configuring Blocking and Rate Limiting Devices
Step 4 Enter the username for that user profile.
sensor(config-net-use)# username username
Step 5 Specify the password for the user.
sensor(config-net-use)# password
Enter password[]: ********
Re-enter password ********
Step 6 Specify the enable password for the user.
sensor(config-net-use)# enable-password
Enter enable-password[]: ********
Re-enter enable-password ********
Step 7 Verify the settings.
sensor(config-net-use)# show settings
profile-name: PROFILE1
-----------------------------------------------
enable-password: <hidden>
password: <hidden>
username: jsmith default:
-----------------------------------------------
sensor(config-net-use)#
Step 8 Exit network access submode.
sensor(config-net-use)# exit
sensor(config-net)# exit
Apply Changes:?[yes]:
Step 9 Press Enter to apply the changes or enter no to discard them.
Configuring Blocking and Rate Limiting Devices
This section describes how to configure devices that the sensor uses to perform blocking or rate limiting.
It contains the following topics:
• How the Sensor Manages Devices, page 14-21
• Configuring the Sensor to Manage Cisco Routers, page 14-23
• Configuring the Sensor to Manage Catalyst 6500 Series Switches and Cisco 7600 Series Routers,
page 14-25
• Configuring the Sensor to Manage Cisco Firewalls, page 14-27
How the Sensor Manages Devices
Note ACLs do not apply to rate limiting devices.