Filter
Top Products
22-28
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 22 Upgrading, Downgrading, and Installing System Images
Installing System Images
Note If the network settings are correct, the system downloads and boots the specified image on the IPS 4510.
Be sure to use the IPS 4510 image.
For More Information
• For more information about TFTP servers, see TFTP Servers, page 22-14.
• For a list of the specific system image files, see IPS 7.1 Upgrade Files, page 22-4.
• For the procedure for locating software on Cisco.com, see Obtaining Cisco IPS Software, page 21-1.
Installing the System Image for the ASA 5500 AIP SSM
This section describes how to install the ASA 5500 AIP SSM system image, and contains the following
topics:
• Reimaging the ASA 5500 AIP SSM, page 22-28
• Reimaging the ASA 5500 AIP SSM Using the recover configure/boot Command, page 22-28
Reimaging the ASA 5500 AIP SSM
You can reimage the ASA 5500 AIP SSM in one of the following ways:
• From the adaptive security appliance using the hw-module module 1 recover configure/boot
command.
• Recovering the application image from the sensor CLI using the recover application-partition
command.
• Upgrading the recovery image from the sensor CLI using the upgrade command.
For More Information
• For the procedure for using the hw-module module 1 recover configure/boot command, see
Reimaging the ASA 5500 AIP SSM Using the recover configure/boot Command, page 22-28.
• For the procedure for recovering the application partition, see Recovering the Application Partition,
page 22-12.
• For the procedure for upgrading the recovery image, see Upgrading the Recovery Partition,
page 22-7.
Reimaging the ASA 5500 AIP SSM Using the recover configure/boot Command
Note Be sure the TFTP server that you specify can transfer files up to 60 MB in size.
Note This process can take approximately 15 minutes to complete, depending on your network and the size
of the image.