Filter
Top Products
16-3
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 16 Working With Configuration Files
Displaying the Current Submode Configuration
Displaying the Current Submode Configuration
Use the show settings command in a submode to display the current configuration of that submode. To
display the current configuration of a submode, follow these steps:
Step 1 Log in to the CLI.
Step 2 Display the current configuration of the service analysis engine submode.
sensor# configure terminal
sensor(config)# service analysis-engine
sensor(config-ana)# show settings
global-parameters
-----------------------------------------------
ip-logging
-----------------------------------------------
max-open-iplog-files: 20 <defaulted>
-----------------------------------------------
-----------------------------------------------
virtual-sensor (min: 1, max: 255, current: 1)
-----------------------------------------------
<protected entry>
name: vs0 <defaulted>
-----------------------------------------------
description: default virtual sensor <defaulted>
signature-definition: sig0 <protected>
event-action-rules: rules0 <protected>
physical-interface (min: 0, max: 999999999, current: 0)
-----------------------------------------------
-----------------------------------------------
logical-interface (min: 0, max: 999999999, current: 0)
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
sensor(config-ana)# exit
sensor(config)# exit
sensor#
Step 3 Display the current configuration of the service anomaly detection submode.
sensor(config)# service anomaly-detection ad0
sensor(config-ano)# show settings
worm-timeout: 600 seconds <defaulted>
learning-accept-mode
-----------------------------------------------
auto
-----------------------------------------------
action: rotate <defaulted>
schedule
-----------------------------------------------
periodic-schedule
-----------------------------------------------
start-time: 10:00:00 <defaulted>
interval: 24 hours <defaulted>
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
internal-zone
-----------------------------------------------
enabled: true <defaulted>