Filter
Top Products
22-19
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1
OL-19892-01
Chapter 22 Upgrading, Downgrading, and Installing System Images
Installing System Images
Link is UP
MAC Address: 0004.23cc.6047
Use ? for help.
rommon #0>
Step 4 If necessary, change the port used for the TFTP download.
rommon #1> interface name
The port in use is listed just after the platform identification. In the example, port Management 0/0 is
being used.
Note The default port used for TFTP downloads is Management 0/0, which corresponds with the
command and control (MGMT) interface of the IPS 4260.
Note Ports Management 0/0 (MGMT) and GigabitEthernet 0/1 (GE 0/1) are labeled on the back of the
chassis.
Step 5 Specify an IP address for the local port on the IPS 4260.
rommon> address ip_address
Note Use the same IP address that is assigned to the IPS 4260.
Step 6 Specify the TFTP server IP address.
rommon> server ip_address
Step 7 Specify the gateway IP address.
rommon> gateway ip_address
Step 8 Verify that you have access to the TFTP server by pinging it from the local Ethernet port.
rommon> ping server_ip_address
rommon> ping server
Step 9 Specify the path and filename on the TFTP file server from which you are downloading the image.
rommon> file path/filename
UNIX Example
rommon> file /system_images/IPS-4260-K9-sys-1.1-a-7.0-4-E4.img
Note The path is relative to the default tftpboot directory of the UNIX TFTP server. Images located
in the default tftpboot directory do not have any directory names or slashes in the file location.
Windows Example
rommon> file <tftpboot_directory>IPS-4260-K9-sys-1.1-a-7.0-4-E4.img