Filter
Top Products
Control Panels, Control Centers, and Keypads | DS7080i | 37
Fire Signal Initiating Circuit (Two-Wire Mode)
Circuit Type: Class B, latching
Supervisory Current: 5 mA
Circuit Voltage: 8.5 VDC to 14.1 VDC
Circuit Resistance: 60 Ω maximum
Current for Alarm: 12 mA minimum
Impedance for Alarm: 1000 Ω maximum
Short Circuit Current: 22 mA maximum
Detector Standby Current: 2.5 mA total
Detectors per Zone: 20 detectors (two-wire) maximum
Inputs
Burglar/Fire Zone: 8 circuits on-board, 24 off-board zones can
be added.
End-of-line resistor: 2.21 kΩ (P/N: 19809)
System Trouble: A separate terminal can be used to monitor
multiple external devices such as phone line
monitors, without using 1 of the 8 zones. A
dry contact output from such a device caus-
es a system trouble.
Keypads
Keypads: 4 maximum
Outputs
Alarm Output: Normally-open, 1.0 A contact connected to
auxiliary power. Can be programmed for
steady or pulsed output.
Programmable Output 1: Solid-state current sink (500 mA maxi-
mum) can be used for alarm, arming state,
or access control. This output is generally
programmable.
Programmable Output 2: Solid-state voltage source (500 mA maxi-
mum). This is the smoke power reset for
Zone 1 when it is used as a fire zone for two-
wire smoke detectors. Can be used for
alarm, arming state, or access control.
Power Requirements
Input Power: 18 VAC, 50 VA, 50 Hz
Output Power: 1.5 A maximum
Auxiliary Power: 10.2 VDC to 14.1 VDC
Auxiliary Current: Total current for all auxiliary devices, in-
cluding keypads and smoke detectors, is
1.0 A standby and 1.5 A alarm.
Panel Standby Current: 115 mA
Ordering Information
DS7080IP32‑BEL Control Panel
For use in Belgium. Includes one control panel
for 220 VAC operation, one enclosure, one lock
set, one transformer, one resistor, and one
hardware pack.
DS7080iP32-BEL
DS7080IP32‑FRA Control Panel
For use in France. Includes one control panel
for 220 VAC operation, one enclosure, one lock
set, one transformer, one resistor, and one
hardware pack.
DS7080IP32-FRA
Accessories
AE1 Standard Enclosure (Gray)
Standard gray enclosure with keyed lock.
Measures 35.6 cm x 31.8 cm x 7.6 cm (14 in.
x 12.5 in. x 3 in.).
AE1
AE3 Large Enclosure (Gray)
Large gray enclosure with keyed lock. Meas-
ures 52.7 cm x 38.1 cm x 10.8 cm (20.7 in. x
15 in. x 4.25 in.).
AE3
www.boschsecurity.com Bosch Security Systems B.V.
1