Filter
Top Products
Conettix - Information Transport Solutions | Conettix IP | 415
Conettix DX4020 Ethernet
Network Interface Module
Features
▶
Built-in IP-based alarm transport, programming, and
control
▶
10BASE‑T or 100BASE‑T network connection
▶
Full‑duplex and half‑duplex support
▶
Three-hole mounting pattern
▶
Support for dynamic or static IP addresses
▶
DIP switches for option bus or SDI bus address
programming
▶
Light emitting diodes (LEDs) provide control panel
status
▶
Supports 128-bit AES Rijndael encryption
The Conettix DX4020 Ethernet Network Interface Module
creates two‑way communications over Ethernet networks
for compatible control panels. Typical uses include:
•
Reporting to the Conettix D6600 Communications
Receiver/Gateway
•
Remote administration with Remote Programming
Software (RPS) or RPS‑Lite
•
Connecting to a PC for programming with PC9000
Software or Building Integration System (BIS) Security
Engine
System Overview
1. Compatible Control Panel
2. Compatible Control Panel Option Bus or SDI Bus Connection
3. Conettix DX4020 Ethernet Network Interface Module
4. Ethernet Network Connection to DX4020
5. Host PC running Conettix D6200 Programming/Administration Soft-
ware
6. Ethernet Network Connection to Host PC Ethernet Network Interface
Card (NIC)
7. Ethernet Network, Local Area Network (LAN), Metropolitan Area Net-
work (MAN), Wide Area Network (WAN), or Internet
8. Ethernet Network Connection to Conettix D6680 Ethernet Network
Adapter
9. Conettix D6680 Ethernet Network Adapter
10. Conettix D6680 Ethernet Network Adapter Connection to Conettix
D6600 Communications Receiver/Gateway COM4 Port
11. Conettix D6600 Communications Receiver/Gateway
The system overview diagram shows a system using a
compatible control panel, Conettix DX4020 Ethernet Network
Interface Module, Conettix D6600 Communications Receiver/
Gateway, and a Conettix D6680 Ethernet Network Adapter.
Functions
LEDs
Red LEDs Function
BUS‑RCV Data bus receives data from control panel
BUS‑XMIT Data bus transmits data to control panel
Green LEDs Function
SER‑RX RS‑232 receives data from serial device
SER‑TX RS‑232 transmits data to serial device
Four LEDs provide information about the transmission and
receipt of data. There are also two network diagnostic LEDs
that provide information about the network connection. Refer
to the DX4020 Installation Guide (P/N 49522) for details
about the network diagnostic LED functions.
DIP Switches
Use the DIP switches to easily assign a bus address to the
DX4020.
Programmable IP Address
Use ARP and Telnet commands from any PC to program the
DX4020 IP address. The IP address can be dynamic using
DHCP or the IP address can be static.
www.boschsecurity.com Bosch Security Systems B.V.
7